Camera Mount for Prusa i3 MK2
Scott Smith

Last updated on December 19th, 2016 at 08:49 pm

Add this to your Original Prusa I3 Mk2 hot bed carriage to easily attach a camera that moves with the print bed.. Slid under the left front hot bed mount screw, remove the front right screw, raise the bed up a 1/4 inch, slide in the long mount then replace the screw firmly. Next if you wish to elevate your camera a couple inches print out the riser and attach to the long mount bar.

Note: Do Not Print this in PLA

cam-mount

Get the download below and have a fun time printing this easy to use camera mount for your printer.
You'll need to create free membership to view the remaining content on this page. Sign up or Login, you'll get more access than when logged in with Facebook...

Join in Comment below...

The screw we are supposed to loosen… is it the top screw or the bottom screw? Have a camera but having a hard time finding where to put it. I’ll give this a try. Thanks.

I actually loosen both the front screws that hold the bed to the metal mount frame below. then the left part of the camera mount slides around the left screw and the right one the stand off goes into the hole. then tighten the 2 screws back.