Infill Visualizer 10-50%
Scott Smith

A simple piece of pre-sliced Gcode for the Prusa i3 MK2 you can print out and have handy for have a hands on sample to review percentages of infill and maybe even show your friends.
Just load this up on your sd card and start printing. This code is pre sliced and heat settings apply for PLA filament. You can however print other filaments by either manually editing the temperature values in the gcode or change the values on your lcd display controller.

This sample print represents cubic infill ranging from 10% on the left up to 50% on the right. 10,20,30,40 & 50%

Download “” – Downloaded 151 times – 43 KB

Join in Comment below...